In general, the ceiling opening would need to be the same dimensions as the staircase less two treads unless you have a low ceiling.  There should always be a minimum headroom of 2m (78") measured from the pitch line of the staircase.

This support pole (G08) provides additional stability to the Kompact and should be installed.  The instructions show you exactly where to place this pole depending on the configuration of your staircase.  It can be fitted down to the floor or sideways into the adjoining wall if necessary. You can download the Installation Instructions from our Services Page.

The standard Kompact kit of 13 risers will fit a floor to floor height of up to 2.86m (9' 4") whilst complying with the UK Building Regulations.  Our regs require a maximum individual tread rise of 22cm; however, the staircase is made in Italy and can be installed with a tread rise of up to 23.5m to comply with regulations in the rest of Europe.  It is important that you are aware of this when looking at details for the Italian staircases in the brochure and on other websites.  We are always happy to advise on the options for your project.

If you have a lower floor to floor height, you will probably just use less of the treads supplied in the kit.  If you floor height is greater, then we can supply additional tread kits and you'll find more details on the accessories page.

The Kompact kit can be installed to fully comply with the UK Building Regulations - but it can also be installed outside the regulations!  As a basic guide, the tread rise should not exceed 22cm and the going must always be set at a minimum 22cm.  However, this may result in the pitch being slightly steeper than the 42 degrees required and you may need to add an additional tread or treads to make the staircase comply.  We can easily and quickly advise on your project.  You would also need to use the riserbars to fit between the open treads to ensure compliance with the Building Regulations' 100mm gap rule.  You'll find all these on our accessories page.

You would also need to install balustrading on any open side of the staircase and these are also available on our accessories page.

Yes, you can buy the matching balustrading kit to use on your stairwell or mezzanine floor, as shown on the right.  You'll find more details on our accessories page.

The beech treads still retain a very slightly grainy texture to them but, if you want to add some extra non-slip treatment, then buy our special Oakleaf Clear Grip Strip shown on our accessories page.  This is a cheap and quick way to add a durable non-slip treatment that is friendly on bare feet!

No.  All you need to do is decide if you need a staircase with one quarter turn (L shape) or two quarter turns (U shape) before you order.  You can rotate the staircase either way when you install it.

The Kompact is available in two widths - 74cm and 89cm.  However, there is now no minimum width required for straight staircases in the Building Regulations, and it should be ok to use the Kompact 74 for a main staircase.  (However, this does not apply in Scotland where they still require the larger width Kompact.)

The base plate measures 21cm diameter.

 

If you'd like more inspiration, click here!